
No hot water? Sometimes the problem isn’t the tank at all — it’s the gas valve. When the gas control valve fails, the burner won’t light or stay lit, and the water never heats up. On this Flagstaff job, the fix was replacing the valve rather than the whole water heater.
What we did
- Removed the old gas valve after shutting off gas and power to the unit.
- Installed the new gas valve and checked the burner assembly while it was open.
- Reconnected the controls and wiring to the new valve.
- Reconnected the gas line, checked for leaks, and relit the water heater.
The result: hot water restored the same visit, without the cost of a full water heater replacement.
Signs your water heater gas valve may be failing
- The pilot or burner won’t light, or goes out shortly after lighting
- Water is lukewarm or runs cold quickly
- The status light on the gas valve is blinking an error code
If you’re seeing any of these, a repair may be all you need. Call Bear Hug Plumbing for water heater repair in Flagstaff and the surrounding area.


